Thingiverse
Armattan chameleon matek tail light support
by Pieterbza
1
Downloads
5
Likes
0
Makes
Printed with PLA, 100%infill with elmers gluestick used on my printerbed at 60°C
Nozzletemp was 205°C on my Wanhao i3
Initially i was going to use this ledboard from matek on a realacc x210 but after purchasing this chameleon frame from Armattan i wanted it to fit so i made this part.
I use 2 M3 screws to fit the ledboard onto this support.
I hope it can be useful for somebody else.
Nozzletemp was 205°C on my Wanhao i3
Initially i was going to use this ledboard from matek on a realacc x210 but after purchasing this chameleon frame from Armattan i wanted it to fit so i made this part.
I use 2 M3 screws to fit the ledboard onto this support.
I hope it can be useful for somebody else.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in