Thingiverse
RadJet 800 Motor Mounts
6
Downloads
10
Likes
0
Makes
Mix and match mount mount for the Radjet 800!
I created these because I have a 2836 motor in the back and an 1800mAH 4s pack in the front.
There are two problems with this idea:
(1) C of G is hopelessly out.
(2) Will the motor hold together on landing?
Use these spacers to adjust your C of G and also make the motor mount more solid.
If you have a big pack in the front then you'll need to move the motor further back to get the C of G in the right place. Use two small spacers followed by t
I created these because I have a 2836 motor in the back and an 1800mAH 4s pack in the front.
There are two problems with this idea:
(1) C of G is hopelessly out.
(2) Will the motor hold together on landing?
Use these spacers to adjust your C of G and also make the motor mount more solid.
If you have a big pack in the front then you'll need to move the motor further back to get the C of G in the right place. Use two small spacers followed by t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in