Thingiverse
Extruder Lever for AURORA A3
by Syumijin
6
Downloads
5
Likes
1
Makes
The extruder of Aurora A3 is inconvenient for replacing the filament.
I improved it.
There is a sharp corner inside the extruder, and the filament is scraped.
To prevent this, we installed a Teflon tube (4 mm * 2 mm) at the upper part.
The lower part was glued with adhesive for ABS after printing.
The cable support in the photo is below.
https://www.thingiverse.com/thing:2411806
I improved it.
There is a sharp corner inside the extruder, and the filament is scraped.
To prevent this, we installed a Teflon tube (4 mm * 2 mm) at the upper part.
The lower part was glued with adhesive for ABS after printing.
The cable support in the photo is below.
https://www.thingiverse.com/thing:2411806
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in