Dual Blower + 40mm Fan for Hypercube v1

Made my own dual blower mount with a 40mm fan. Wanted to have my blowers get enough air flow so I kept the blowers higher up. So far it has performed really well. I printed them all at 0.2 layer height but they could be done anywhere up to 0.3mm. All printed in PETG.

I designed the mount to allow me to zip tie my cable wraps and have a more secure wiring harness. An E3D sock is necessary for this!

I think there is room for improvement so I'm dubbing this v1, hopefully I'll have time over t