Thingiverse
Landing gear for Phoenix gliders
by Tal_N
50
Downloads
37
Likes
0
Makes
This is landing gear for Phoenix 2000 and Evolution gliders.
As I am mostly flying on flat field and no grass. I got tired of gravel landings and set out to install a landing gear.
This was 3D designed and printed for 35mm foam wheel.
I did no cuts on the hull and gliding performance not affected.
Print is done in two halves and glued together with CA glue.
glued to the hull with Gorilla glue.
Place it where it fits best according to the hull's curve just under the wing's leading
As I am mostly flying on flat field and no grass. I got tired of gravel landings and set out to install a landing gear.
This was 3D designed and printed for 35mm foam wheel.
I did no cuts on the hull and gliding performance not affected.
Print is done in two halves and glued together with CA glue.
glued to the hull with Gorilla glue.
Place it where it fits best according to the hull's curve just under the wing's leading
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in