S&W M&P Shield Magazine Pocket Holster – 3D printable model from Thingiverse Thingiverse

S&W M&P Shield Magazine Pocket Holster

101 Downloads
47 Likes
0 Makes
Download Model
This is a pocket holster for the Smith and Wesson M&P Shield 9mm. I used a pocket clip from a cheap folding knife and a couple small neodymium magnets from a hobby store. I just glued the magnets into the two circular holes and screwed the pocket clip onto the other side. I did not add screw holes into the design, I just used a small drill bit instead. I wear this in my front right pocket with the front of the magazine facing forward. If you would like to wear it on the other side, the mirror or
Source
Thingiverse
Comments
0
Makes
0

Makes

Rating

Noch keine Ratingen

Comments

No comments yet – be the first!
All Thingiverse Models More by Bradel12

Similar Models

6 Suggestions

Add to Collection