Werkzeughaltersystem fuer Gewindeschneiderset; toolbox for a set of screwplate

Servus,

I got me here made €‹a complete system for tool holder. I do not like when the tool is loose in the case.

So now I have a separate holder for each tool creates. This holder can be screwed onto a plywood board now. (Spax 3 m). Holes for the screws are integrated.

I then installed these plywood panels vertically with U-profiles in a Tanos Systainer http://www.systainer.de. On an area of €‹300 mm x 400 mm I get so below about 60 tools (screwdriver, wrench set, pliers, el