Thingiverse
Sololink board
by wildtypitch
7
Downloads
7
Likes
0
Makes
Simple case for those looking to house their sololink (If they're taking the sololink out of the solo to install on another UAV)
Has two antenna ports at the bottom for a standard antenna mount, use screws to mount to the three columns. rear hole for reset/bind button and another hole for to read the blinky blinky LED's. Hole at top for cable routing. Vent holes on side and bottom.
Has two antenna ports at the bottom for a standard antenna mount, use screws to mount to the three columns. rear hole for reset/bind button and another hole for to read the blinky blinky LED's. Hole at top for cable routing. Vent holes on side and bottom.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in