Thingiverse
Spool Support
by mtimmerm
8
Downloads
7
Likes
0
Makes
Two-piece spool support. We don't need no stinking bearings.
Holds a variety of 1kg spool sizes up to 210mm diameter or up to 95mm thick (not quite at the same time, but that would be bigger than 1kg).
The stop has a taper fit into the base, and should be inserted snugly, but not super tightly.
Ideally use with an adapter for the spool that provides a 13mm hole. If I have to design any, I'll add them as I need them.
The spool adapters shown in the photo come from here: https://www.
Holds a variety of 1kg spool sizes up to 210mm diameter or up to 95mm thick (not quite at the same time, but that would be bigger than 1kg).
The stop has a taper fit into the base, and should be inserted snugly, but not super tightly.
Ideally use with an adapter for the spool that provides a 13mm hole. If I have to design any, I'll add them as I need them.
The spool adapters shown in the photo come from here: https://www.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in