Thingiverse
MPSM SD Card Tool
by Dr_Joel
37
Downloads
20
Likes
1
Makes
Reload of https://www.thingiverse.com/thing:2025037 without any name
Print flat with support, then remove support. I think you could also print on the side but not sure if it works as well. No support is generated under the handle, just in the mouth of it, at least with cura. print with magic number 0.175 or 0.0875
Print flat with support, then remove support. I think you could also print on the side but not sure if it works as well. No support is generated under the handle, just in the mouth of it, at least with cura. print with magic number 0.175 or 0.0875
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in