Thingiverse
1/4 inch to hot shoe adapter
by diarx
94
Downloads
69
Likes
2
Makes
A quick hatchet job 1/4 inch to hot shoe adapter with a printed thread (the other one I found on here required a 1/4 inch nut which I didn't have on hand).
I've used this to adapt a small camera tripod (Fotopro FY-583) to hold a Rode Videomic Pro hot shoe. Assuming it should work with all Rode videomic models.
Should print in PLA with no support in the default orientation with no problems.
The thread for this design was borrowed from wizprods adapter (this part was a bit beyond my low
I've used this to adapt a small camera tripod (Fotopro FY-583) to hold a Rode Videomic Pro hot shoe. Assuming it should work with all Rode videomic models.
Should print in PLA with no support in the default orientation with no problems.
The thread for this design was borrowed from wizprods adapter (this part was a bit beyond my low
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in