Thingiverse
filament guide for bearing - Ultimaker 2
by iNoob
2
Downloads
2
Likes
0
Makes
I wanted to print TPU with my Ultimaker 2. So i changed my feeder to this one:
https://www.youmagine.com/designs/alternative-um2-feeder-version-two
my filament slipped always off the bearing and wasnt pushed to the extruder anymore. So i printed a small slipp on ("add-on") for the bearing, that should keep the filament in line. Only use it with flex-filament.
It works so far! You just need to adjust the Robert-feeder a little bit.
Printed with 100%infill ABS (PLA will break)
https://www.youmagine.com/designs/alternative-um2-feeder-version-two
my filament slipped always off the bearing and wasnt pushed to the extruder anymore. So i printed a small slipp on ("add-on") for the bearing, that should keep the filament in line. Only use it with flex-filament.
It works so far! You just need to adjust the Robert-feeder a little bit.
Printed with 100%infill ABS (PLA will break)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in