Thingiverse
Prusa I3 MK2S Y-Axis guide/brace RJ4JP 0108
25
Downloads
22
Likes
0
Makes
Update: Be carefull with the screws not to crack the braces!
Slightly widening the holes could be neccessary!
A brace for the right side of the Y-Axis.
I noticed that I could wiggle my bed a little and made this thing which basically
is based on thing https://www.thingiverse.com/thing:1848700 (Thank You for that!) but completly built from scratch.
For the right brace take one of those bearings and cut it in the middle and
use sanding paper or whatever to shorten both halves about 1mm.
Slightly widening the holes could be neccessary!
A brace for the right side of the Y-Axis.
I noticed that I could wiggle my bed a little and made this thing which basically
is based on thing https://www.thingiverse.com/thing:1848700 (Thank You for that!) but completly built from scratch.
For the right brace take one of those bearings and cut it in the middle and
use sanding paper or whatever to shorten both halves about 1mm.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in