Propel Sky Master Cam Gimbal house

I designed this to replace the gimbal motor housing on my new Propel Sky Master drone which crashed on 1st flight. The original motor housing was trashed from the impact. I lost some of the Isolation dampers. So the design is around the dampers I found in the link below.
I reused the old lid.
The small piece for pivot simply glues into place with very little deburring to fit. Be careful not to remove too much.

https://www.ebay.com/itm/ALIGN-RUBBER-DAMPER-RED-30-GG3009XXT-FREE-USA-SHIPPI