Thingiverse
PETG Adhesion Test for CR-10
by dargul
55
Downloads
42
Likes
0
Makes
#### First Layer Improvement Thing.
Ok, this sure is a very simple thing, but while struggling with an adhesion problem on the first layer I thought maybe this is helpful for others, too.
It's an one layer flat square (50x50 mm).
The two photos of the thing show what my problem was while I was dialing in the config for my new CR-10 printing PETG from DasFilament.
(Added the screenshots of my final S3D config)
##### Update: 31.12.2017
Config screens corrected.
Just realized I upl
Ok, this sure is a very simple thing, but while struggling with an adhesion problem on the first layer I thought maybe this is helpful for others, too.
It's an one layer flat square (50x50 mm).
The two photos of the thing show what my problem was while I was dialing in the config for my new CR-10 printing PETG from DasFilament.
(Added the screenshots of my final S3D config)
##### Update: 31.12.2017
Config screens corrected.
Just realized I upl
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in