Thingiverse
PugLight
by Zatamite
7
Downloads
8
Likes
0
Makes
Short and squat pug flashlight.
5-6 snug fitting pieces.
Cree xp led (xp-e or xp-l) on star
simple solders on star
switch still to be added.
Uses single cr123a battery.
Minimal Material.
The walls may seem thin on the body of the pug light but once all the components are assembled/installed the flashlight is very rigid. I am considering thinning out the walls on the parabolic front end just to save material.
Printed in PLA... and the parts remain tight enough. You may want to c
5-6 snug fitting pieces.
Cree xp led (xp-e or xp-l) on star
simple solders on star
switch still to be added.
Uses single cr123a battery.
Minimal Material.
The walls may seem thin on the body of the pug light but once all the components are assembled/installed the flashlight is very rigid. I am considering thinning out the walls on the parabolic front end just to save material.
Printed in PLA... and the parts remain tight enough. You may want to c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in