X-axis Tensioner to avoid forces on Z-axis

This remix allows you to tension the belt without putting the tension in the belt back through the z-axis linear guides. The tension in the belt becomes a compression force on the x-axis linear guides through the two screws that thread into small nuts pressed into the plate on the end of the axis.

Note: Tensioner.step is the same as Y-Yoke.stl

You will also need:
3mm screws x3
3mm nuts x3
3mm washer x1
3-5mm drill bit (and a tool to run it in)
The bearings, screw, and nut from the or