Thingiverse
6mm Rod End Bearing/Rose Joint
29
Downloads
38
Likes
0
Makes
I had a couple of bad rod end bearings on my G2S, so wanted something to tide me over until replacements arrived.
These have a 6mm centre hole, and an M6 thread in the base, although all sizes are set exact with no tolerance, so you may need to file or tap some areas depending on the accuracy of your printer.
As regards extra parts, you'll need 2xM3 8mm screws, and I'd also recommend an M6 nut to use to lock the rod-end to the rod, as I don't know that threadlock would do the job here.
My c
These have a 6mm centre hole, and an M6 thread in the base, although all sizes are set exact with no tolerance, so you may need to file or tap some areas depending on the accuracy of your printer.
As regards extra parts, you'll need 2xM3 8mm screws, and I'd also recommend an M6 nut to use to lock the rod-end to the rod, as I don't know that threadlock would do the job here.
My c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in