Thingiverse
nerf dart repair
by andrewwaack
8
Downloads
8
Likes
0
Makes
for nerf darts to repair the rear damage caused by miss load
printed in pla
use your own printer settings
inserts in to back of dart
tested on a modulas regulator
flywheel blaster
V2.1 is 11.85mms across base and only 1mms thick still 20mms long
I noticed the darts where flying woky I think this fixes this isue
printed in pla
use your own printer settings
inserts in to back of dart
tested on a modulas regulator
flywheel blaster
V2.1 is 11.85mms across base and only 1mms thick still 20mms long
I noticed the darts where flying woky I think this fixes this isue
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in