Thingiverse
HyperLite Superstrong Pod
by Engineer_Fpv
27
Downloads
20
Likes
0
Makes
For the hyperlite evo/ss
Must print in TPU
m3 screws with 7-10mm long( can use m3 nuts, i never actually did).
I have been using a unify vtx and i have my antenna(aomway) inside the pod, you can use any antenna as you like with a pigtail, or you can have in on the bracket as stock.
Foxeer hs1177 camera mounted with the U bracket in the middle screw.
2.5mm foxeer lens.
The lens/camera are fully protected from the pod and no surroundings
It took some really good crashes, Super strong
St
Must print in TPU
m3 screws with 7-10mm long( can use m3 nuts, i never actually did).
I have been using a unify vtx and i have my antenna(aomway) inside the pod, you can use any antenna as you like with a pigtail, or you can have in on the bracket as stock.
Foxeer hs1177 camera mounted with the U bracket in the middle screw.
2.5mm foxeer lens.
The lens/camera are fully protected from the pod and no surroundings
It took some really good crashes, Super strong
St
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in