LED Light CR-10/CR-10s Fan Blower Mount (No Screws Needed)

I was looking for a light that could go over my prints while printing but couldn't find anything so I decide to design my own. Also, I made it so you don't have to use any screws. It lights up your prints while your printing.



Directions:
Mount onto the 2 extra screw holes on the fan blowers.

For the LED's:
To power the LED's I cut the two wires to the cooling fan for the extruder. Then I soldered just the positive wire to the fan coolers positive wire. Next, I ran the ground wire a