Thingiverse
CR-10 upgrade Dual Z from single stepper
by stevenfayers
342
Downloads
231
Likes
0
Makes
This is my attempt at dual-Z upgrade for CR-10 using a single stepper motor.
It uses a 600mm lead screw kit such as this one:
https://www.ebay.co.uk/itm/3D-Printer-T8-Trapezoidal-Lead-Screw-Rod-W-Nut-Coupling-Shaft-Bearing-Mount-Set/152604546903?hash=item2387f09757:m:mBqqygoYqpae9LmSj9iyFCQ
making use of the pillow block bearings and lead screw nut that are provided in the kit.
Also requires:
2x 20 tooth 8mm hole GT2 drive pullet
1x 20 tooth 8mm hold GT2 smooth idler
1x 760mm GT2
It uses a 600mm lead screw kit such as this one:
https://www.ebay.co.uk/itm/3D-Printer-T8-Trapezoidal-Lead-Screw-Rod-W-Nut-Coupling-Shaft-Bearing-Mount-Set/152604546903?hash=item2387f09757:m:mBqqygoYqpae9LmSj9iyFCQ
making use of the pillow block bearings and lead screw nut that are provided in the kit.
Also requires:
2x 20 tooth 8mm hole GT2 drive pullet
1x 20 tooth 8mm hold GT2 smooth idler
1x 760mm GT2
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in