Thingiverse
Cr-10 S5 Reinforced Y stepper brace
by PDTRob
60
Downloads
34
Likes
0
Makes
Mod of Scholle_ y motor brace as his did not fit my CR_10 S5 as it needed 10 mm removed.
2x M4x10 with two hammer nuts to mount everything on the CR10
4x M3x60 screws (the original is too short) to mount the brace on the motor
Printed and tested. Clears the bed reinforcements fine,plastic caps need to be removed.
2x M4x10 with two hammer nuts to mount everything on the CR10
4x M3x60 screws (the original is too short) to mount the brace on the motor
Printed and tested. Clears the bed reinforcements fine,plastic caps need to be removed.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in