Thingiverse
HyphyLite GoPro Mount - 35 Degrees
by HyphPV
4
Downloads
2
Likes
0
Makes
35 degree GoPro Session mount for the HyphyLite frame. Utilizes two screws in the rear, in addition to the washers provided in the kits as well as a single zip tie in the center. Pairs up with my GoPro Session bumper, found here: http://bit.ly/2CHoW7s
The washers are primarily for aesthetics in other cases, but for a TPU print such as this they serve to widen the footprint of the screw head and prevent the TPU from tearing around the screw.
Print in TPU, on its side with no supports.
The washers are primarily for aesthetics in other cases, but for a TPU print such as this they serve to widen the footprint of the screw head and prevent the TPU from tearing around the screw.
Print in TPU, on its side with no supports.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in