Thingiverse
SCTouch DIY BLTouch Z Probe
by chanders
51
Downloads
30
Likes
0
Makes
SCTouch(TM)
1. No force required
2. No “bellying” in the middle due to rod flex
3. I have been as cost effective as I could
4. You will need to cut the leg off the 3mm Allen/hex key “probe” with a Dremel or hacksaw
5. Designed to drop in any inductive/capacitance probe mount!
Note: I was too lazy to implement a solenoid to retract/deploy the probe as the ROI was not making much sense to me
Yu can get the time square magnets from an old CD or DVD drive.
Probing is done VERY infreque
1. No force required
2. No “bellying” in the middle due to rod flex
3. I have been as cost effective as I could
4. You will need to cut the leg off the 3mm Allen/hex key “probe” with a Dremel or hacksaw
5. Designed to drop in any inductive/capacitance probe mount!
Note: I was too lazy to implement a solenoid to retract/deploy the probe as the ROI was not making much sense to me
Yu can get the time square magnets from an old CD or DVD drive.
Probing is done VERY infreque
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in