Thingiverse
MKS TFT32 CR-10 front mount
by Haabilo
28
Downloads
14
Likes
0
Makes
**REV2 is the recommended one**
I had taken some measurements wrongly and the leg "holes" were a bit too close together. Rev2 fixes that and also adds some relief in corners that turned out weaker than expected.
Designed in Fusion 360. "Fixed" in 3D Builder.
I designed this mount for a friend and thought to upload it here as well.
This was done in a few hours, so any improvements on the design are welcome.
It should be oriented in the way that it is supposed to print.
I had taken some measurements wrongly and the leg "holes" were a bit too close together. Rev2 fixes that and also adds some relief in corners that turned out weaker than expected.
Designed in Fusion 360. "Fixed" in 3D Builder.
I designed this mount for a friend and thought to upload it here as well.
This was done in a few hours, so any improvements on the design are welcome.
It should be oriented in the way that it is supposed to print.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in