Thingiverse
Avid brake bleed adapter (M5 screw to 6mm tube)
by LSM87
58
Downloads
52
Likes
0
Makes
This is an adapter to fit Avid Elixir brakes for the bleeding procedure of brake fluid.
It connects between a tube (6mm inner diameter) and the M5 thread.
Use a wrench size 9 to tighten or loosen.
Print with 100% infill, with the thread in an upright position. Print with slow speed.
Be careful with the thread (when printed in PLA)! It might break and get stuck in your brakes. Better use sturdier filament.
It connects between a tube (6mm inner diameter) and the M5 thread.
Use a wrench size 9 to tighten or loosen.
Print with 100% infill, with the thread in an upright position. Print with slow speed.
Be careful with the thread (when printed in PLA)! It might break and get stuck in your brakes. Better use sturdier filament.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in