Thingiverse
K8203 PTFE Liner cutting guide
6
Downloads
2
Likes
0
Makes
The Heat isolator in the K8400/K8203 extruder has a small PTFE lining tube that needs to be replaced from time to time.
It must be replaced by a new sleeve cut to 23.0mm +- 0.15mm.
It is a pain to cut this straight and exactly the right length by hand.
Just push the sleeve into this guide, then use the ends as a guide and trim with a sharp knife. It will help keep the cuts straight, and the length will be 23mm
It must be replaced by a new sleeve cut to 23.0mm +- 0.15mm.
It is a pain to cut this straight and exactly the right length by hand.
Just push the sleeve into this guide, then use the ends as a guide and trim with a sharp knife. It will help keep the cuts straight, and the length will be 23mm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in