X Axis Tronxy p802ma Belt tensioner FOR TOOTHED BEARING - REMIX

If you can't print this, please consider ordering it through my 3DHub at:
http://3dhubs.com/service/8Bit

This is designed so that you can take a TOOTHED bearing and use that on your belt. It allows for a much straighter, better belt alignment, with higher accuracy on jerk movements. I used these bearings off amazon, but any 16 or 20 (20 is less accuracy) toothed bearing will work. Additionally, you will need 1x30mm M3 screw and 1-3 M3 nuts, depending on your preference. I used 3 nuts, one on