Thingiverse
3S Lipo Battery holder for QuadCopter
by Jonesmg1
67
Downloads
40
Likes
0
Makes
3S Lipo Battery Holder designed for an SK450 quadcopter frame.
This is designed to better position the underslung battery on an SK450 dead cat quadcopter frame. The positioning of the screw holes allows it to be move fore-aft to adjust center-of-gravity (CG).
The hole sizes will fit M3 a little tight - probably better to use M2 or M2.5.
Update:
Had a slight issue with the strap ears on the rear tray breaking, so I made them thicker and printed it slower at 230C for better layer
This is designed to better position the underslung battery on an SK450 dead cat quadcopter frame. The positioning of the screw holes allows it to be move fore-aft to adjust center-of-gravity (CG).
The hole sizes will fit M3 a little tight - probably better to use M2 or M2.5.
Update:
Had a slight issue with the strap ears on the rear tray breaking, so I made them thicker and printed it slower at 230C for better layer
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in