Thingiverse
Peon230 Antenna Mount
by rage1618
2
Downloads
2
Likes
0
Makes
This is an antenna mount for the Peon230 3D printed quadcopter.
I needed something to support the two antennas of my FrSky reciever at 90 degrees to each other.
The mount slots in to 3 slots near the quadcopter "logo" on the top plate and is secured by zip-ties.
The two circular holes are designed to fit a 3mm straw to support the antennas or you can secure the antennas to the zip-ties.
The larger hole in the middle was intended to allow an FPV antenna to come up through the support
I needed something to support the two antennas of my FrSky reciever at 90 degrees to each other.
The mount slots in to 3 slots near the quadcopter "logo" on the top plate and is secured by zip-ties.
The two circular holes are designed to fit a 3mm straw to support the antennas or you can secure the antennas to the zip-ties.
The larger hole in the middle was intended to allow an FPV antenna to come up through the support
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in