Anycubic Prusa I3 DIY Ultrabase cord Ramp

When I was doing "larger prints" on my DIY Anycubic Pruse I3, the cord that powers the Ultrabase heated Bed would drop into the lower area and tangle the belt, tap the micro switch, or Bind up the base on it's return.

I create a ramp that slides over the end Printer end cap right in a pre-made groove. The cord now slides (and is guided) along that unit.

NOTE: You may have to adjust the "Shark Fin" height to make it work with your ultra-base, depending on where it end up after you level it