Thingiverse
Martian II Radio Stack
by carbrf
43
Downloads
33
Likes
1
Makes
Took a few designs I liked and made a VTX/RX mount to sit in the rear of the Martian II. This works with an X4R RX and many generic 200/600mw VTX's.
There are 3 pieces or layers:
Layer 1 (bottom) is for the X4R RX.
Layer 2 (middle) is for the VTX
Layer 3 (top) is the VTX cover.
The antenna wires are meant to come out the front holes and curve around into the antenna tubes, as shown in pictures 3&4.
Printable antenna tubes are also included, but I recommend using real ones, as the
There are 3 pieces or layers:
Layer 1 (bottom) is for the X4R RX.
Layer 2 (middle) is for the VTX
Layer 3 (top) is the VTX cover.
The antenna wires are meant to come out the front holes and curve around into the antenna tubes, as shown in pictures 3&4.
Printable antenna tubes are also included, but I recommend using real ones, as the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in