Thingiverse
ANET A8 Frame Brace
by Mr_Dabrudda
22
Downloads
12
Likes
0
Makes
A remix of an ANET A8 frame brace. I printed the original and could not get the nuts to thread on.
Print four Nuts
Push the frame apart with the tightening nut...do NOT pull the frame together or the Pipe part may snap like mine did. (Apparently 3D printed parts can't withstand pulling forces) I welded my Pipe section back together by dipping the ABS into an Acetone and ABS slurry and letting it dry.
Print four Nuts
Push the frame apart with the tightening nut...do NOT pull the frame together or the Pipe part may snap like mine did. (Apparently 3D printed parts can't withstand pulling forces) I welded my Pipe section back together by dipping the ABS into an Acetone and ABS slurry and letting it dry.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in