Bowden Inlet Tube Filiment Guide Edge Mount

I made this to go with my Dual Extruder setup from https://www.thingiverse.com/thing:2734717 and Anet A8 spool mount from www.thingiverse.com/thing:2081054 I like the spools on the back but I put my extruder drives on top of the Z axis posts so getting filiment into them was a bit of a pain until I made this.

It mounts to the frame and the hole is sized for an M6 tap to fit standard bowden tube fittings. I suggest using a 1.6mm build wall to fit the tap. I used some inexpensive metric tap d