Thingiverse
Brocca
by mikeprusa
485
Downloads
348
Likes
3
Makes
Brocca
The idea of this model is to make a spiral object like a vase, but also useful.
I used cura engine on repetier host, and for the red and green translucent PETG i set a temperature of 220°C , a shell thickness of 1 mm, a Top/Bottom thickness of 1 mm, and spiralize contour in general extruder setting. I changed the nozzle with a 0,8 mm nozzle and set layer to 0,3mm.
I also set minimum layer time to 10 seconds ( in spiral mode is a "turn" ), for me was the best layer time to avoid deform
The idea of this model is to make a spiral object like a vase, but also useful.
I used cura engine on repetier host, and for the red and green translucent PETG i set a temperature of 220°C , a shell thickness of 1 mm, a Top/Bottom thickness of 1 mm, and spiralize contour in general extruder setting. I changed the nozzle with a 0,8 mm nozzle and set layer to 0,3mm.
I also set minimum layer time to 10 seconds ( in spiral mode is a "turn" ), for me was the best layer time to avoid deform
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in