Thingiverse
Strix Goblin Cam and GPS Nose Mount
by jamesdowning
13
Downloads
8
Likes
0
Makes
Swift mount for strix goblin nose.
Mount is printed upside down. Tray then mounts on top to aid in GPS mounting.
From left mounting point to right mounting point is 63mm. Units were incorrect on export, so be sure to resize (reduce the size by a factor of 1000, if I recall).
To mount, drill a hole in the middle of the mold witness lines on the nose of the Goblin, try to make this hole as tight as possible to your camera lens. Match drill holes on the NACA ducts on the left and right
Mount is printed upside down. Tray then mounts on top to aid in GPS mounting.
From left mounting point to right mounting point is 63mm. Units were incorrect on export, so be sure to resize (reduce the size by a factor of 1000, if I recall).
To mount, drill a hole in the middle of the mold witness lines on the nose of the Goblin, try to make this hole as tight as possible to your camera lens. Match drill holes on the NACA ducts on the left and right
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in