Thingiverse
Pencil Holder for Desk
by wwiens
26
Downloads
30
Likes
0
Makes
This is a pencil holder that I designed to clip onto the edge of a craft table. It has 74 9mm holes in the top and a grid on the bottom for pencil alignment. It was designed specifically for Caran d'Ache Colored and Derwent Pencils but should fit most similar pencils.
The edge clip fits the desk with friction and is pretty snug after some testing. Note that this was created for a craft desk with a 15mm thickness. You will have to adjust for your setup.
The top and bottom print separately.
The edge clip fits the desk with friction and is pretty snug after some testing. Note that this was created for a craft desk with a 15mm thickness. You will have to adjust for your setup.
The top and bottom print separately.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in