Thingiverse
Pill dispenser
33
Downloads
21
Likes
0
Makes
Fill the tube with pills and dispense them one at a time with every full rotation.
Assemble the pieces based on the photos. You will need a metal pin for the center post and also a metal pin to attach the bracket at the bottom. For the lower pin, I used 14 gauge copper wire. The metal pin is from a printer disassembly or something and it is 4.76mm diameter.
The small recessed holes are for magnets. I was going to use them to kinda lock in the various positions, but I was not impressed,
Assemble the pieces based on the photos. You will need a metal pin for the center post and also a metal pin to attach the bracket at the bottom. For the lower pin, I used 14 gauge copper wire. The metal pin is from a printer disassembly or something and it is 4.76mm diameter.
The small recessed holes are for magnets. I was going to use them to kinda lock in the various positions, but I was not impressed,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in