Thingiverse
Geeetech i3 GT2 Y Axis Mount
by atrixium
7
Downloads
6
Likes
0
Makes
This is a replacement for the crappy original y axis mount provided by Geeetech in their i3c kit and probably others as well.
The hole spacing is 1 CM and the holes are 2.75mm diameter so the stock 3mm bolts thread into them, no nuts required.
The gap for the belt is a snug fit @ 1.05 MM, you may need to alter it if your printer tolerances aren't great, but it should work for most I think.
The hole spacing is 1 CM and the holes are 2.75mm diameter so the stock 3mm bolts thread into them, no nuts required.
The gap for the belt is a snug fit @ 1.05 MM, you may need to alter it if your printer tolerances aren't great, but it should work for most I think.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in