Thingiverse
Martian II Runcam and Gopro Hotswap
by AirFreak
1
Downloads
0
Likes
0
Makes
Max. electronic-height 25mm.
Backplate can mount fpv-antenna and rc-receiver-antenna.
Camnera angle 35°
To fit the screws make them hot and screw them in.
V1:
The groove is there so the Gopro ejects while a crash. The one on the Photo is already glued.
V2:
When the copter fell down the whole front was still working, but didn`t look good.
In order to mount the upper part use some rubberbands and little "sticks" to mount.
The holes are not included you may need
Backplate can mount fpv-antenna and rc-receiver-antenna.
Camnera angle 35°
To fit the screws make them hot and screw them in.
V1:
The groove is there so the Gopro ejects while a crash. The one on the Photo is already glued.
V2:
When the copter fell down the whole front was still working, but didn`t look good.
In order to mount the upper part use some rubberbands and little "sticks" to mount.
The holes are not included you may need
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in