Thingiverse
E3D Titan extruder for i3 - Modified
by jhitesma
2
Downloads
1
Likes
0
Makes
Gyrobot's X-carriage was close to what I wanted - but not quite perfect for my needs...so...
Changes include:
Switched to a 3 linear bearing setup instead of four.
Zip tie slots slightly wider to fit my zip ties better.
Added 2 loops on the front to tie off wires from the hot end (which I ended up not being able to use.)
Added a loop on the back to tie off wires from my cooling fan and differential IR sensor.
Added a mount for the differential IR sensor.
I did all of this in OnShape
Changes include:
Switched to a 3 linear bearing setup instead of four.
Zip tie slots slightly wider to fit my zip ties better.
Added 2 loops on the front to tie off wires from the hot end (which I ended up not being able to use.)
Added a loop on the back to tie off wires from my cooling fan and differential IR sensor.
Added a mount for the differential IR sensor.
I did all of this in OnShape
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in