Thingiverse
Delta 31-460 Belt Sander Replacement Upper Pulley MkII
by elfworks
4
Downloads
6
Likes
0
Makes
Was asked to remix the remix. :)
This should have the correct tooth spacing to match the diameter of the pulley. (24mm vs 16mm = 150% more teeth.)
If I were to print a top cap, it would be printed separately, and glued together, as shown in this sample.
This should have the correct tooth spacing to match the diameter of the pulley. (24mm vs 16mm = 150% more teeth.)
If I were to print a top cap, it would be printed separately, and glued together, as shown in this sample.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in