Thingiverse
Spool Holder
by Smiley88
9
Downloads
7
Likes
0
Makes
Bei diesem Spoolholder wird das Filament nicht über die Achse gezogen sondern sehr schonend über die Kugellager und man kann ihn in der breite verstellen. Man benötigt dazu ( siehe Bild ):
1x M 10 Gewindestange oder Schraube
8x M 10 Mutter
4x Unterlagscheibe
4x Kugellager
With this spool holder the filament is not pulled over the axle but very gently over the ball bearings and one can adjust it in the width. You need it (see picture):
1x M 10 threaded rod or screw
8x M10 mother
4x wash
1x M 10 Gewindestange oder Schraube
8x M 10 Mutter
4x Unterlagscheibe
4x Kugellager
With this spool holder the filament is not pulled over the axle but very gently over the ball bearings and one can adjust it in the width. You need it (see picture):
1x M 10 threaded rod or screw
8x M10 mother
4x wash
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in