Thingiverse
15mm x 5mm magnet holder
by db2000
7
Downloads
5
Likes
0
Makes
15mm x 5mm magnet holder.
The hole for the magnet is a little undersized so the printed part can be heated a little (eg hot water if using PLA) and press fit. Or use some glue or if your magnet has a hole in center - a screw. I went with heating and press fit and its been solid.
i didn't use any support when printing, the inside roof of the hole where the magnet goes is a fair span (15mm of unsupported distance) and so that particular surface wasn't perfect but it worked fine and its beh
The hole for the magnet is a little undersized so the printed part can be heated a little (eg hot water if using PLA) and press fit. Or use some glue or if your magnet has a hole in center - a screw. I went with heating and press fit and its been solid.
i didn't use any support when printing, the inside roof of the hole where the magnet goes is a fair span (15mm of unsupported distance) and so that particular surface wasn't perfect but it worked fine and its beh
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in