Thingiverse
18mm ABL Sensor Holder for Stock CR10 / CR10s
by crix26
36
Downloads
23
Likes
0
Makes
This is an Holder for an 18mm ABL Sensor to be mounted on the Stock Printhead of an CR10 or CR10s.
This Design holds the Sensor in two clamps and you don't need the Nuts to position the sensor but can adjust by hand.
This Design holds the Sensor in two clamps and you don't need the Nuts to position the sensor but can adjust by hand.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in