Thingiverse
Samsung remote holder w/o screws version 3
by vapefreak
2
Downloads
2
Likes
0
Makes
I created this version 3 of the remote control holder without screws for more surface area for the double sided sticky tape and a hole where you can slide your finger along to "eject" the remote control right into your hand.
This thing is more easily to mount flush under the edge of a table.
I changed the design a bit to print it on the back without the need of supports.
Print Settings
Infill: 20%
Raft: no
Support: no
Layer: 0,2mm
Nozzle: 200°
Bed: 60°
Used Filament:
h
This thing is more easily to mount flush under the edge of a table.
I changed the design a bit to print it on the back without the need of supports.
Print Settings
Infill: 20%
Raft: no
Support: no
Layer: 0,2mm
Nozzle: 200°
Bed: 60°
Used Filament:
h
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in