Thingiverse
Pinball drop targets WITH RESET DIY
by mitchell_cj
186
Downloads
119
Likes
2
Makes
A modular pinball drop target.
As part of my DIY pinball project i needed to design some drop targets.
This is a complete/final model that works just fine.
I used a small piece of elastic band to put tension on the target, i tried using a spring but it was too much for the servo. perhaps a softer spring could work.
Servo motor: Tower pro (13mm*24mm)
Micro switch with NC & NO contacts.
The model was designed in Fusion360 and is included for download. It has been a long work in progres
As part of my DIY pinball project i needed to design some drop targets.
This is a complete/final model that works just fine.
I used a small piece of elastic band to put tension on the target, i tried using a spring but it was too much for the servo. perhaps a softer spring could work.
Servo motor: Tower pro (13mm*24mm)
Micro switch with NC & NO contacts.
The model was designed in Fusion360 and is included for download. It has been a long work in progres
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in