Thingiverse
Z Limiter Zonestar P802Q
by msavazzi
2
Downloads
1
Likes
0
Makes
On my zonestar the Z axis tuning is VERY annoying.
Mainly because the screw is too short and the spring too long. Also the screw is not aligned to the top of the dip switch bar but to the middle.
So I decided to change it.
This will extend to the top of the limiter gaining some mm there.
Also the screw should be put upside down so the head is below the limiter, then the limiter, the spring then the holder and ontop of everything the plastic bolt or a metal bolt.
MUCH easier to tune it.
Mainly because the screw is too short and the spring too long. Also the screw is not aligned to the top of the dip switch bar but to the middle.
So I decided to change it.
This will extend to the top of the limiter gaining some mm there.
Also the screw should be put upside down so the head is below the limiter, then the limiter, the spring then the holder and ontop of everything the plastic bolt or a metal bolt.
MUCH easier to tune it.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in