Thingiverse
USB Volume Knob - 38mm
by spepin
32
Downloads
22
Likes
0
Makes
This is a base for a USB volume control. I have created an Instructable for this project, and you can follow along at https://www.instructables.com/id/USB-Volume-Control/
The base is shown as printed (upside-down) to minimize support. The rectangular block outside the base is there to eliminate a tall, thin, unstable tower of support material which would separate from the print bed.
Also included is a DXF file of the bottom cover, which can either be 3D printed or laser cut out of acryli
The base is shown as printed (upside-down) to minimize support. The rectangular block outside the base is there to eliminate a tall, thin, unstable tower of support material which would separate from the print bed.
Also included is a DXF file of the bottom cover, which can either be 3D printed or laser cut out of acryli
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in